Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
After removing a MX67 running MX17.3 from a network in Dashboard - no psysical movement or disconnets, then I added the device into a new created network - a downgrade to MX15.44 happend.The device are fuctioning well, but I need to use AnyConnect th...
HiI'tried to connect my Netgear 3G modem in bridge mode to an Cisco ISR4331 on Gi0/0/1 configured as DHCP adressing.When I connect the 3G modem to PC's, then I got the public address and a subnet mask of 255.255.255.255 - It is working at my PC and I...
Hi I have a project where I use a ISR4331 as DHCP server. I need to assign same the same IP address to the same mac address at every connection. There is around 150 devices to be connected and therefore I'm trying to avoid making a BIG config file wi...
Yes - I can connect different PC - all get the sam public IP.The ISR don't get any address at all. When trying to set the adress manually with the subnet mask of 255.255.255.255 - it's not possible?Is ther som limitations in IOS XE? /MR
HiI don't think it's a right solution. I have to configure a temporary site2site VPN connection - until the customers ISP can install a fixed fiber connection-
HiUnfortunately the router don't get IP address if assigned to DHCP client.Show, ip, int, br show that the link is up but interface IP is unassigned.Br,Michael
Tank you all - I've just hoped that a solution like Cisco Meraki was available.I've choosen to assign static adresses to the devices instead. Best regards,Michael
