Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Have IOS 12.2(2)T running on Cisco 2610. Need Firewall Feature Set. Is there any way to upgrade without buying another fully flegded IOS release (as my resseller insists that it's the only way to go)?Thanks.Joe P.
My platform is a Cisco 2610. The IOS image is "c2600-i-mz.122-2.T.bin. Need to configure CBAC. The Feature Navigator Tool lists both the IOS Firewall Feature Set and CBAC as supported by my platform running the above ios version. However, when I iss...
Hi all! Trying to configure CBAC on 2610 running IOS ver.12.2(2)T. My Cisco reseller insists my platform supports the Cisco IOS Firewall Feature set. However, whenever I issue the command ''show ip inspect all'' to verify the CBAC capability, the out...
Have my 1601 NAT-enabled (with static entries for web, mail and dns servers) but all connections to the webserver on the lan side are failing and all virtually hosted domains are not accesible. Any workaound (so that NAT could forward external conne...
Our Cisco 1601 router is repeatedly failing to resume operations normally whenever powered off or each time after power failure! It constantly boots in ROM Monitor mode and we always have to reset before operations resume normally. Any thoughts/ad...
Thanks gfullage for the reply. I am unsuccessfully trying a simple search (on Cisco main page) to get to the IOS 12.2(2)T download page without getting the right link! Any hint?Furthermore, is the download/IOS Firewall Feature set free? If not how to...
Dear Catherine,The most relevant info from the 'sh ver ' output is as follows:*system image file is 'flash:c2600-i-mz.122-2.T.bin'*IOS (tm) C2600 Software (C2600-I-M), Version 12.2(2)T, RELEASE SOFTWARE (fc1).Should you need any other detail, kindly ...
Thanks Jeff for your reply. Schematically the setup is as this: LAN (with Private IPs) > NATed Router (1601 with static entries of the type "ip nat inside source static Server Private IP Server Public IP extendable") > Public Network (Internet).In...
Thanks John for your replies. However, the boot value (config-register ) reads exactly 0x2102, reason why the reported behavior is confusing me!Thanks again for any other comment!Joe P.
