CBAC Config on 2610 running IOS 12.2(2)T

[jpac]

Hi all! Trying to configure CBAC on 2610 running IOS ver.12.2(2)T. My Cisco reseller insists my platform supports the Cisco IOS Firewall Feature set. However, whenever I issue the command ''show ip inspect all'' to verify the CBAC capability, the output shows that the CBAC is not supported (% Invalid input detected at '^' marker)! Any comment/help will be appreciated!

Thanks.

Joe P.

[mclach]

Hi Joe,

What we need to do is check the actualy image you are running with a "sh version" off the router.

You should have this image:

"c2600-io3-mz.122-2.T.bin".

Please post us the image name and we can take it from there.

R/Catherine

[jpac]

Dear Catherine,

The most relevant info from the 'sh ver ' output is as follows:

*system image file is 'flash:c2600-i-mz.122-2.T.bin'*IOS (tm) C2600 Software (C2600-I-M), Version 12.2(2)T, RELEASE SOFTWARE (fc1).

Should you need any other detail, kindly let me know.

Regards.

Joe P.