Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We just upgraded a 4235 sensor to IPS 5.0. I can only access it via https on one machine. On every other machine I go to I have the same problem. I open up a browser and type in the URL. I get prompted a couple of times about a certificate and I ...
I had to configure my C3620 router to use inbound V.120 calls because we have to use TACACS+ authentication. Is it possible to use multilink to combine two lines? I am dialing in using an ADTRAN Express XRT TA and have it set to V.120. I have Wind...
Hi George, yes I´ve seen this issue, If the IDM applet starts but it won't finish loading then you need to upgrade (or downgrade) the Java VM version.1. Go to tools>internet options> advanced2. Make sure you have the following options checked/uncheke...
Thanks for the response. I have been eliminating non-essential logging. However I am still receiving the messages. I need to log as much inbound information as possible. How do I perform option #2?
I added the debug statements and I don't see anything different.Aug 7 09:55:34.293: ISDN Se1/0:23: RX <- SETUP pd = 8 callref = 0x014AAug 7 09:55:34.293: Bearer Capability i = 0x8890Aug 7 09:55:34.297: Channel ID i = 0xE1808388Aug...
Correct, my problem is that I can not initiate a 2nd channel call into the 3620. For my purposes, bringing up the second line at the beginning of the call is adequate. I do not need to bring the line up and down during the call. I will save that f...
