Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I’m configuring a wireless bridge using two AP1562I-E-K9 in mesh with Mobility Express.The AP are powered by catalyst C3650C-8PC-S switches.During startup the AP is unable to connect to the controller and I see the messages “Radio1 not started,...
Hi,I am in exactly the same situation as jeffkushner.I have already tried to change the port configuration, the PoE configuration and disable CDP.After one or two hours the AP starts working.With a 802.3at PoE power injector it works.The AP1562 produ...
No, it's all regular.Debugging ILPWER I see that the AP requires 15.4W at startup then it requires 29.8W when turn on the radio and says "not enough POE power". I attach the debug log.
Hi Cristian,Thank you for the advice. But I have a 3560C switch (802.3at, 30W PoE+).In the AP1562 product specification there is this note:Note: If 802.3at Power over Ethernet (PoE) is the source of power, the 1562I radios will shift from 3 x 3 to 2 ...
When powered by poe+ switch the access point seems to retry continually and after 1 or 2 hours it connects and works.With power injector (Microsemi 9001GR, 30 W) it works immediately. Did you power the AP with Cisco poe+ switch?
