Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I recently bought an Aironet 340 model AIR-AP342E2C and according to the documentation it is suppose to support 128 bit encryption. However, when I go to the security setup configuration page the only option available to me for the key size is "not s...
My question is that I've assigned an IP and mask to E0 and the only way that I can access this interface is by enabling IP host-routing. When I ran debug all I noticed that packets where getting to the router but the router could not respond back wit...
I've recently purchased 3 2500 series routers to setup a lab in order to study for the CCNP. My question is that I've assigned an IP and mask to E0 and the only way that I can access this interface is by enabling IP host-routing. When I ran debug all...
The 128 bit option was not available even before the firmware upgrade. So I'm not sure this maybe the case. However you noted that this is a know problem...if it is just a matter of a user-license Key why couldn't I just re-apply the key instead of r...
If you do a "sh version" what does the configuration register show? It would be something like 0x2102 if it is something other than this then you may have to change it to this, which will allow you to save your running config to startup config.
If your config register is set to 0x2142 this will happen for more information on these settings you can check out:http://www.cisco.com/warp/public/63/lose_config_6201.html
Yes the interface was brought up with the "no shutdown" command...and when I run debug I can see packets from workstations to the router interface but the responses back from the router get a "unrouteable" error message.
