Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Guys does anyone know if the most recent 12.2 IOS code for the 6500 (sup 720) is capable of doing IPSEC VPN's without the VPN module? I can't seem to find a definitive answer to this on the website.Thanks!
Hello, We have a customer who has an iprism web filter which I thought was only doing content filtering. After installing an IPS 4215 to monitor web traffic, the only alarms that generate are http connect alarms from the inside hosts to the iprism, i...
Hello, We are considering implementing contexts to control access for a number of agencies' traffic we manage. I have some questions about contexts I haven't been able to find clear answers to:1) In a failover FWSM setup, if one primary context goes ...
Hello, One of the many problems we have had with our recent upgrade to VMS 2.3/IPS 5.1 is now we are unable to push out signature updates to the 5.1 senors (The updates to 4.x work fine). The error we are getting seems to be related to VMS:Local MC: ...
Hello, We recently upgraded our 4235 and 4240 up to 5.1. Both sensors were previously runing 4.1 code. Now, the sensors will stop sending alarms after a random amount of time - one sensor shows the analysis engine not running, the other does - howeve...
Yes, its probably seeing an encrypted session to the proxy. I am hoping their IT guy can find a way to turn that off in the iprism. Interesting that I had the exact same problem before with an MS proxy environment too. Might be the default type of se...
Hi, thanks... Unfortunately that's where the problem seems to be coming from. All ports are spanned on the 2950 including the one that connects the inside interface of the iprism. As best I can tell the hosts authenticate to the iprism web page which...
Thank you Patrick, that is most helpful. One last question about the conversion - So according to the doc's the old single context config is saved to a file and you can then load that saved config into a new context within the new multi-context space...
Hello, I have come accross a similar problem to the above where a customer had several subnets that were located behind a router that was attached to the local LAN and the hosts on the local LAN had a PIX 7.x as their default gateway, the PIX had rou...
Thanks, as a workaround I have been able to login the service account and issue the following - /etc/init.d/cids stop/etc/init.d/cids startUpon doing this the events start to flow again, however, this requires constant monitoring on my part. Is there...
