Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Everyone!I need to remove the Standby FW from our Active/Standby setup. Are you aware of anything specific that needs to be done? I have checked everywhere on the web, but there doesn't seem to be anything that I have to do prior to disconnecting ...
Hi All, We have a UCS server that has 3 NIC - 1 Management (CIMC) and 2 10Gb NICs. One of those 10Gb interfaces is using a static VLAN6 (10.10.6.x) address and the other a static VLAN7 (10.10.7.x) address. Each of those uses an Ethernet cable and con...
Hi Guys,
We have 2 stacked switches (WS-C2960XR-24TD-I). One is configured as a Master and the other as Member.
I changed the console password on the Master switch and that works fine. I plugged into the console port of the member and I can see ...
Hi,
We have an ASA 5516X running 9.5(2) and we need to upgrade the OS, in order to get a feature to edit the AnyConnect Connection Profile Options (XML). The recommended version is 9.6(2), but I can see that 9.9.1 is the most recent version.
What...
Hi,
We have an ASA 5516X running 9.5(2) and we need to upgrade the OS, in order to get a feature to edit the AnyConnect Connection Profile Options (XML). We were advised to go on to 9.6(2) which is the currently recommended version, but I can see t...
Hi, Thank you for the advice, I had a look on the server and I can see those options (see attached/below image).I have tried to use every single one, and when I did, I also removed the native VLAN or changed the native VLAN statement on the switch, b...
Thank you for your reply. I wasn't able to see where to configure the settings on the server itself.I spoke to TAC, however, and they advised that we have to configure the VLAN (6) as a native in the port that was previously changed as an access port...
Hi,I am currently seeing the same issue on my MS220-8P. I have a very easy setup - a router -> Switch -> AP. Apart from this, I have 2 end devices connected to the switch.---Apr 9 22:57:34 Port STP change Port 8 disabled→designatedApr 9 22:57:34 Port...
