Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hey everyone I'm running into an issue with recursive routing and can't seem to figure out how to fix it. I have an IPSEC with GRE runnning OSPF. The tunnel comes up fine but OSPF is flapping. It appears that the route to the destination is via the t...
I've established a IPSEC GRE tunnel between two sites but cannot ping either end. I'm not seeing errors on the tunnel, it's up and active. The research I've done hasn't been helpful in my particular situation. I believe my ACL's are correct. My confi...
I apologize if this is posted in the wrong location. I'm standing up an IPSEC tunnel between two sites. Eventually all sites will use the head end as a backup connection. The tunnel establishes but I'm not seeing an OSPF adjacency nor can I ping the ...
I have conifigured a IPSEC tunnel between a remote site and the corporate office. I configured the IP helper on the interfaces so the devices will contact the corporate DHCP server....so nothing is natt'ed. The tunnel comes up just fine. I can access...
I have a Cisco 3650 running 16.3.5b Lan base. I want do disable the login but prompt for the enable password with connecting via the console cable. I am using AAA for ssh access. The "no login local" command isn't an option under line con 0. aaa grou...
I found the issue. The branch router was learning the its WAN gateway through OSPF. Sure enough there is a static route for that IP pointing to a firewall. I added a static route on the branch router point to the WAN interface and that was it. I can ...
I'll continue working with the VRF but it looks like I will need to change the tunnel configuration also.
Yes the OSPF adjacency is flapping. I can ping the tunnel IP's but nothing else.
Configure the WAN in a VRF on the spoke? I can ping the tunnel IP but nothing else. There is a typo in the config file....trying to mask the public IP.
I made that change on the branch and I'm still seeing the same looped chain message. Here is the sh ip NHRP result.
Router#sh ip nhrp10.192.0.254/32 via 10.192.0.254 - I think this is the problem.Tunnel1 created 00:02:56, never expireType: static, ...
