Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone,As I've mentioned before, I'm a bit new at routing and am just trying to get a real feel for some basic routing concepts.Here's the scenario: (This will explain what I've done so far, in addition to what I'm trying to accomplish.)I have o...
Hi everyone,I'm pretty new at routing and don't have much experience in it other than what I've learned in CCNA. I'm going for my CCNP now and am starting to study for ROUTE. As such, I need to lab, lab, lab.Please bear with me as I'm pretty much n...
Ok, I "get it" much better now!I added the second drop from the Linksys to the 2650 and put it on VLAN 20.Now, everything works as I had hoped.I removed the "ip nat outside" statement just to prove that this would disable connectivity and sure enough...
I tried the new config but I'm not able to ping my Linksys (192.168.1.1) from the Cisco 2600.I did add VLAN 20 on the switch (port 20 and 21.)Here's the configs for the router and the switchRouter:Router#show runBuilding configuration...Current confi...
I will rate your posts right now.I will also select the correct answer once I can confirm everything works, which I hope will be later tonight.Thanks so much Roberto!
Ok, got it.I will give it a shot.You have been very kind in taking the time for me on this and I can't thank you enough for that, Roberto.Thanks again!
