Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,
What is the command to check the VPN session information (like when is the user logged in and how long is he connected to) on the Cisco ASA & Cisco ISR Routers.
-Nithin.
Hi,I have a Cisco CAT6K switch (WS-C6506-E) and a SUP 720 engine installed on the slot 5.I would like to know whether this Supervisor Engine 720, currently on slot 5 be changed to slot 6 and if so, does it require any configuration change? Regards,Ni...
Hi Tim,Regarding the TLS1.1 and TLS1.2, there's no specific reason for that. We had just enabled only TLSv1.Regarding the cipher, we had enabled only "RSA_WITH_3DES_EDE_CBC_SHA" in the parameter-map.Regards,Nithin.
Hi Tim,Thanks a lot for your reply.In the parameter-map, we have given #no version ssl3 and given version TLS1. In #sh stats crypto client, we are able to see the SSL authentication cache hits.+-----------------------------------------------++--- Cry...
Hi Tim,We are also facing the same issue. We have upgraded to A5(3.1b). We have configured the following on the Cisco ACE.Please find attached the configs and # sh stats crypto client ouput done on the ACE. Even after the configs, SSLv3 authenticatio...
Hi Rakesh,Yes, if I reload the switch, it comes up normally.CAT6K-SW01#dir all-filesystems Directory of system:/ 2 -r-- 0 <no date> default-running-config 3 dr-x 0 <no date> memory ...
