Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,Following the Cisco Config guide (https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/ipaddr_nat/configuration/xe-16/nat-xe-16-book/iadnat-cgn.html) for ASR1001-X, I have configured Dynamic Port Address CGN and it is operational. The following a...
Hi Community,I am in desperate need of direction/assistance. In trying to achieve my aim, I keep going around in circles, not getting any closer.I have a Catalyst 3850 with several VLAN Trunk Ports with multiple VLANs on each.I need to apply shaping ...
Hi Community,I have a Catalyst 3850 running IOS 16.3.I have several VLANs on an 802.1Q Trunk, being delivered by a service provider (SP). I need to individually Shape traffic for each VLAN. When I use the Shaping Average command, I receive the follow...
Hi Team,I have Configured NAT64 on an ASR. It appears everything is working as required until the outgoing DNS64 Addressed IPv6 packets 'hit the NAT64 server (ASR)' on Int GE0/0/0. Int GE0/0/3.31211 is connected to the IPv6 only host. Keen to hear wh...
Hi Folks,I am an IPv6 newbie and I have a problem.We have been using an ASR1001-X as our Border/Transit router successfully on IPv4 running eBGP and internally to L3 Switch using OSPF.I have successful eBGP IPv6 session with ISP. I can ping public IP...
Hi,That is certainly not something you want to be doing all the time. No solution as yet, although I have made some changes to our network recently and plan to test the CGNAT again soon. BTW, I answered Paul's post above - we are using external publi...
Hi Georg, Apologies for leaving this subject for several months. Further to the running config I posted in October, I realised I did not provide the sh int ouput for our Outgoing interfaces. Please see below: GigabitEthernet0/0/0 is up, line protocol...
Hi Joseph,Apologies for the lack of clarity. Point taken with the Voice Class. I have updated to Match dscp efAlso, this switch provides the Access layer for customer circuits (the VLANs) to connect to our Network Node. INT GE1/0/1 is the upstream li...
