Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello
when a BD subnet is advertised over an OSPF L3out, i'm seeing tha subnet as E2 external route with metric 20 on the router connectd to BL (VPC link).
Why the subnet is shown as external and not internal OSPF route? Why the metric is 20 ?
Regard...
Hello,
I have a L3Out connected to a cluster of 2 physical Firewalls with 2 VPC links. the 2 VPC links uses vlan 200. I want to use that l3out in a service graph as PBR destination. the vlan 200 is a part of a L3 domain
When creating L4-L7 device, I ...
Hi experts,
is it possible to have an aci multipod fabric with a mixed spine switch models, Nexus N9K-C9332C and Nexus N9K-C93600CD-GX
- 100G spine - Lieaf
- Same software release
Regards
Hi,
I have a L2 aci Fabric (2xSpine and 4xLeafs) in production, release 4.2(6h) i have a requierement to enable Rogue EP Control feature. is there any impact doing so ?
Regards
Hello,
Thank you for your feedback
My question was regarding the type of the remote leaf uplinks interface type
I have seen that document. I was a bit confused by the paragraph "1G or 10G connectivity from remote leaf switches to upstream Router" whe...
One last question if I may.
On the document there are 2 sections, what is the difference between the two ?
- Installing Cisco APIC Software Using Virtual Media
- Installing Cisco APIC Software Using CIMC Virtual Media
Regards
