About Terence_721

Terence_721 · 07-25-2023

I'm replacing an old edge device with two Cisco 8300 routers; Dual ISP setup. The 8300 routers were also ordered with 4 port LAN modules. I'm putting together the config before the routers have arrived and want to figure out the down stream config. ...

Terence_721 · 06-21-2021

I have a older pair of 4900M L3 switches as the CORE in a small datacenter. The purpose of this was to limit access between a few devices within vlan70. When we applied the VACL to the Core switch, all connectivity to and from vlan70 was lost. I lo...

Terence_721 · 07-26-2023

I scanned through the Cisco doc on interchassis high availability. It appears the deployment model has one active and one standby router. I need both routers actively routing traffic for this project, so I don't think HA will work for me. It maybe...

Terence_721 · 07-26-2023

I'll have to look at the deployment model in that document. It may be something to consider. Thanks.

Terence_721 · 07-26-2023

Ok, it sounds like it is a valid design, thanks for confirming. Yes, I was planning on using the LAN module interfaces to interconnect to the two routers for the L2 connection.

Member Since	‎10-26-2017 12:11 PM
Date Last Visited	‎10-08-2024 03:50 AM
Posts	5
Total Helpful Votes Received	1

User Statistics

User Activity

Replacing edge with a pair of Cisco 8300 edge platforms

VACL dropped all VLAN traffic -why?

Re: Replacing edge with a pair of Cisco 8300 edge platforms

Re: Replacing edge with a pair of Cisco 8300 edge platforms

Re: Replacing edge with a pair of Cisco 8300 edge platforms