Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a Cisco 3925 and Cisco 2960S directly connected by to physical gigabit interfaces, One interface (Data) is working as expected, the other (Guest) is seen as a CDP Neighbor, I can ping it, but I cannot get the 2960 to pass traffic over it. The ...
Yes I was referring to the lab stack, should not have posted that with the response to your request.
To answer your question;
When I configured a PC with a static IP address, DFG, and DNS (for Guest network) and connected it to the 2960 in a port c...
SW01#show mac address-table | include 9a09 4 4403.a73b.9a09 DYNAMIC Gi1/0/46
I have configured DHCP for test data and guest networks on the router. Trunked switchports accordingly and connected a pc to interfaces in VLAN's 4 & 2, pulls correct DHCP a...
Thanks once again for your advise. I will move the management IP address to interface VLAN 1, to match the other 4 switches. I will have to use the current address as this is a remote site.
Since this is a production network I have decided I am goi...
I really appreciate your assistance with this problem. I believe I should revert to Layer 2 switching. This would also allow me to utilize the Layer 2 switches purchased to complete this and other network upgrades. The only reason I enabled layer 3 s...
