About pthompson208

pthompson208 · 01-25-2012

I was assigned to configure our 2811 router and i have never worked with IOS before now, so I am very new to this. The below configuration is working right now but it just seems to be a little bit off. I can not ping anything from the LAN and DNS tak...

pthompson208 · 01-30-2012

Here is the log from LAN to internet.NAT*: s=10.10.0.51->75.123.45.67, d=50.16.37.159 [3050]NAT*: s=10.10.0.51->75.123.45.67, d=74.125.227.159 [3051]NAT*: s=10.10.0.51->75.123.45.67, d=74.125.227.159 [3052]NAT*: s=10.10.0.51->75.123.45.67, d=50.16.3...

pthompson208 · 01-30-2012

We actaully have several external static IP addresses. For example this is what the config would look like with the example static IP addresses.interface FastEthernet0/1description WAN Interfaceip address 75.123.45.67 255.xxx.xxx.xxxip access-group ...

pthompson208 · 01-27-2012

Thank you for the excelent suggestions. I did not even know that the ZBF even existed on the 2811 router. Although after researching it a little bit it seems to be a bit complicated but it is a very good idea if I can implement it correctly. Eugen I...

pthompson208 · 01-26-2012

Im sorry it may have been confusing what I was explaining before but what I want is this. I want to be able to allow all traffic on all ports 80, 443 etc, going from my LAN network (10.10.0.0) out to the internet WAN. But obviously I do not want to ...

Member Since	‎01-25-2012 06:10 PM
Date Last Visited	‎08-18-2017 03:51 AM
Posts	5

User Statistics

User Activity

Cisco 2811 router configuration help

Re: Cisco 2811 router configuration help

Re: Cisco 2811 router configuration help

Re: Cisco 2811 router configuration help

Cisco 2811 router configuration help