Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Everyone,Object tracking with static routes allows you to monitor a target with the ability to remove and then add a new route to the routing table, but in my scenario, when the target is unreachable (upstream device), I would like to stop adverti...
Has anyone used the EIGRP neighbor command on the ASA to enable unicast hellos and dynamic routing between two ASAs over a site to site VPN tunnel? I'd like to see if it is possible to eliminate an external router needed to build a GRE tunnel and in...
Would route tracking work in the following scenario?DSL and T1 links connected to the same ASA. The t1 will be used for a site to site VPN tunnel using dynamic routing over the tunnel. The tunnel should only be used to reach those destination netwo...
David,No problem on the bundle. I was looking at the ASA5525-IPS-K9 (adding in SSDs is possible under that main part number), but then adding on spare SKUs for AVC/WSE. From what you're saying, this will work in 9.2, but the install for AVC/WSE, wi...
What's the verdict here?Can you order ASA5525-IPS-K9, add SSD drives, and then add spare SKUs for NGFW AVS/WSE licensing? Of if you use SSD drives to get CX functionality, are you limited to the "lite" ASA NGFW IPS?
Thanks. The issue is my customer already has a VM deployed on UCS B-Series with more than enough resources than required per the design guide (8 cores, 4-6GB RAM etc.), but is still experiencing issues with ACS 5.2. They are now looking into purcha...
This scenario is actually the opposite of a floating static actually. Static is peferred and should the next hop go down via object tracking it should learn a new route via a dynamic routing protocol.The question still is can object tracking be conf...
