Hi,I have a 2611 router configured for DDR and multilink. I have a load-threshold set to save some $$ on per minute charges. I have one BRI connected to router. I am using a dialer interface and have two dialer strings configured. When the threshold ...

Hi,I have a 2600 router with 4 BRI's and an ethernet. I configured a dialer interface and rotary group for the BRI's.I have a valid IP address on my ethernet port.I've configured dialer interface for "ip unnumbered fastethernet 0/0"I've configured th...

Hi there,If I had a cisco 1720 router with a serial interface, would it be possible to connect this interface to an ISDN modem and BRI(s) and have it complete a call? Reason I ask is that the router with one serial interface would be cheaper than bu...

Hi there,I'm looking for a Mux or similar device that I can connect to a PRI and split out several BRI's for seperate connections to routers and video equipment. I've found the Adtran Atlas 550 will do this, but was wondering if anyone knew of a chea...