Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Running into problem with VPN Concentrator setup for static, one-to-one nat behind a PIX 515E firewall. Trying to connect PIX 501 hardware client to concentrator behind 515E.NAT works fine for software-based remote access vpns, however the hardware ...
Does anyone know if Cisco plans on integrating the ability to check if a remote-access VPN system is running pre-defined anti-virus software (similar to checking for a pre-defined Client Firwall being installed and running on the remote system)?Thank...
"Fat-fingered" confreg at the "rommon 2>" prompt.Entered: confreg 0x21242Should have entered: confreg 0x2142After entering reset, only got CCCCCCCCCCCC in the hyperterm session...Powered down router and tried to hyperterm...could not connect to route...
Best practice question...Is it better to perform PAT via a NAT overload on a bastion router with a static statement on the PIX, or setup PAT on the PIX using one global IP address?Other alternatives?***Router Example***Router Setupip nat pool FirstPA...
I have reset PIX firewalls passwords many times, howeve I have a delima. I have inherited a PIX firewall where the console port on the PIX is severly damaged (missing internal jack connectors/wires). PIX is not under warranty. PIX properly works.....
Solution to "Major" ProblemPlaced a jumper on pins 1 & 2 on the DUART Reset jumper pins. Pins 1 & 2 forces the console baud speed to 9600.Problem solved.Reset confreg to 0x2102.Good to go.URL Links of interest:Boson Config Register Calculator:http:/...
The post from nkhawaja is correct. The PIX can only pass IP traffic.However, there is a way to pass SNA through a PIX firewall. Is the SNA traffic originating from an AS/400 or mainframe? If so I can guide you in how to pass the SNA traffic. Let ...
Concerning Phase1 and Phase 2 Settings: The admin of the Watchguard peer states that the VPN settings are an exact mirror of the settings I have on the PIX. I will ask for screen-shots of the Watchguard settings to verify that the settings are inde...
Below are two different debugs. The first debug is of the VPN between my PIX firewall and a remote Watchguard firewall that does not work. The second debug is of a VPN between the same PIX firewall and a remote Checkpoint firewall that does work. Tho...
