Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, We are using 831 for remote SOHO office. It is set up with EzVPN between 831 and Cisco VPN concentrator 3030 at the hub site. I tried to HTTP access the 831 local Ethernet interface E0 via the VPN tunnel but failed. I know there is a simi...
Hi,Marco I am a new user of Cisco IDSM-2 module on 6513. We are running CatOS 8.1 with MSFC2. The IDS module itself is running OS 4.1(1)S47. I have some basic questions regarding the IDS module. 1. There are two options to capture traffic, one i...
When you configure the PIX, usually there is a new nat pool assoicated with the incoming VPN user. You can use this access control list to restrict the VPN user access. For example: the pool for the VPN user is 10.10.10.0/24 and the only server th...
You may turn on the logging and try again to see whether it will give me some hints.logging onlogging buffer 7IP protocol 50 & 51 are standard ESP & AH used by IPSec SA and UDP 500 is ISAKMP used by IKE. There may be some other ports need to be open...
You may also use the "setup" command under PIX configuration mode and the interactive setup wizard will help you to finalize other parameters, such as time zone, password and etc. The only difference from direct http command is that you can only con...
Maybe you can try ping from outside firewall to kiwi syslog server first to make sure the network connectivity is there since you already have some ICMP access control lists applied on the same outside interface. If it is pingable, then take a look a...
