Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I dont need nat,so I use the no nat,but it not work,but even I use the nat (inside)0 0,I just can ping the other end,the other end can't ping back ,finally,the "nat (inside) 0 access-list acl-in" resolve this problem.my question is:what's the "no nat...
I want to use ping to check the backup CSS's status, I can ping the master's heartbeat interface's IP address,but can't ping the other end's.I was try to use ACL,but its not work.So, how can I do it.thanks
Hi,I have two pix,version and interface as follow.when I implement failover(rs232 and crossover cable connected),there is some problem.when the secondary pix power up,the two pix state will changed frequency.however,the pix connect to css11151(also c...
the situation as follow:two css,each separate connect to one pix inside int;two pix and css configure to failover, polling time 15 secset the css type redundancy-up,when pix outside link down or inside link down,standby pix will become active,then it...
I have already resolve it. set the 3550 interface mode to access,because if CSS connect to two 3550,the interface will become trunk mode.Either two CSS and two 3550 connect to VLAN1,each CSS connect to each 3550's interface fa0/1 and fa0/2,3550 conn...
