Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I'm about to unleash a 525 to replace our old firewall, but I have some questions about some issues I haven't been able to figure out yet:1. Our old firewall did stateful http inspection, etc, and also acted as a http proxy. In short, people with...
Hi, I've read docs and searched through the archives here but haven't been able to figure out this problem.No one laugh, but here's my config...CallManager @ v3.22600 @ v12.1(5)YB2and they're talking over H323 (Is this the problem?)I've recently acqu...
Hi. I have a 2600 (12.1(5)) hooked in to my CM with a T1PRI for calls. I have found out that if you call our unpublished yet accessible incomming "DID" number from the outside, you get a local dialtone, and it allows for outgoing calls with the 9T de...
Hi. I've recently set up partitions etc to help control toll and long distance dialing. I set up some route filters that limit which area codes can be dialed (I think / I hope!). However, in my custom made filters, when a "restricted" phone dials an ...
This past week I've had my call manager service stop on my unexpectedly -- each time with the following error:The Cisco CallManager service terminated unexpectedly. It has done this 1 time(s). The following corrective action will be taken in 60000 ...
You can check the system/application event log on the call manager server. From there you can deduce whether the service was automatically restarted, or if the computer went through a restart sequence.-JDN
Thanks, all, that was precisely what I needed to do. I removed all the information from my Gateway and set the information up in my routing patterns and created a seperate CSS/pattern for my groups of callerid info.-JDN
I had tried that in the past, and just confirmed... even if I set the "External Phone Number Mask" for that line to 3450XXX and I also tried 3450113, but it still shows the 9 instead of the 0. I did find, for the first time, the Use Calling Party's E...
I'm looking for the same thing... I want to deploy a bunch of new Cisco AiroNet APs, but also have a considerable investment in Lucent/Agere/Wavelan AP-1000s that do RADIUS lookups for MAC addresses. I don't care about WEP key management... I just wa...
Okay -- with that lead, I tried fooling around with different call scenarios with call waiting situations.If I'm on the line and I pick up the phone when a second caller calls, when I hang up on #2, I am still able to transfer the first caller's stre...
