Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
How is it possible for a pix to do name resolution to handle a command such as "access-list outside_in permit tcp host mail.test.com host x.x.x.x eq smtp"Thanks
Hello,I have a pix 501 working perfectly.I need to enable vpn passthrouh for clients on the inside network using cisco vpn client to connect to several remote devices on the net.This is possible with a linksys but i can't manage to do it with the pix...
Hello,I am building a bridge betweem two BR350. One is root and the other client. The authentication seems to be OK.When i look at the assocaciation table, i can see the remote bridge, the state is Assoc and parent [self]. If i clic on the mac addres...
I use a 827 to connect to internet (with nat overlaod).The connexion gives a public IP address. I use a private Ip address on ethernet0 on the router and another one on the outside interface of the pix.I have two other Public IP addresses.I want to u...
I have a Pix 501 connected to a DSL Modem using pppoe. The PDM is 6.2(1). In this case i have just one Public ip address.Can someone tell me how to host an Microsoft exchange server behind teh pix, and make the smtp relay service work correctlyThanks...
HelloThe problem is that i need to use the name of a server that has multiple Ip addressses that can change.It is an antivirus mail server relay.I would like to accept only smtp traffic comming from this particular server name.It is not possible to ...
Thankyou for the info.I added:fixup protocol esp-ikeisakmp nat-traversalaccess-list inside_in permit udp any any eq 500I had to disable isakmpNow the ipsec tunnel is negotiated. The security policies are negotiated.The remote device (another pix 501...
Isnt it possible to do a static nat of all ports and all addresses from the outside interface (public address) of the 827 to the outside interface (private address) of the pix 501? Is there another scenario i can use to have the same result with jus...
