Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have noticed that with some IOS I can issue both show disk0: and dir disk0: but others recognize only the last one. I would like to know if this is because the command show disk0: is not in use any more in newer versions or if it is a bug.regards,...
I have several devices connected to a wire, let's say 210.20.0.0/25. There's RIP configured among them, that way:!router rip version 2 redistribute connected redistribute static network 210.20.0.0 no auto-summary!One of the devices, 210.20.0.1, has a...
Hello,I have some Cisco 801 with IOS: - C800-Y6-MW.121-3.XG4 - C800-G3-MW.120-3.T1when configuring them, after issuing -aaa new model-,the command -aaa authentication login default ?- shows you: enable line local local-case nonebut not the options r...
Hi,I have two questions regarding bridging configuration.1) Let's suppose I want a router just bridge IP but not route it. I just have to create one or more bridge groups and then link to them the desired interfaces. But to let all work I have to do...
My customer is configuring a DNS for CLNS, when issuing show clns ne, show clns se, etc....the entries contain the device address but not the DNS' associated name address. Is there any way of making the router learn and print the name instead the ...
Thanks for your quick response.Regarding the second question. As you say, Using CRB you can route OR bridge IP on one particular interface, but working in this model, you can change the command bridge crb for bridge irb, leaving the rest of the confi...
