Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiWe have a 4506 with sup4 running IOS 12.2(20)EW.Ip access-list lines with 'log' do not log a message to syslog or the console. This work OK on our cat5K RSMs. Any idea what I have configured incorrectly on the cat4k?4506#sh logSyslog logging: ena...
HiI have a 7206vxr with NPE-225 processor. We are about to remove a couple of cards and install a new ATM card. I have discovered that this will take it over the limit of 800 points.I/O cont with 1 FE 200 HighPA-A3-OC3SMI 300 HighPA-2...
HiWe may have an overscription problem as the 'Rx-No-Pkt-Buff' counters are incrementing on some interfaces. Have searched cisco.com but cannot find any information on this. Can you please send a link or more information explaining what the counter...
As previously stated, it is not ideal to bridge over a WAN links but it can be done.We did something similar when relocating a site with an ATM link. The routers bridged between sites over an ATM link. The switch interfaces connected to the router ...
I would suspect a loop because of the flapping messages. Maybe the second phone is connected back to another switch interface or some other device.Are you seeing spanning tree topology changes?
Spanning tree will do this. Suggest you look at changing the main switch to be spanning tree root and if a standby main switch make it root secondary. If both the edage switch links are going to the same main switch you may need to change port costs...
Check the QoS configuration guide. If running IOS the following should help:http://www.cisco.com/en/US/customer/products/hw/switches/ps4324/products_configuration_guide_chapter09186a00803671bd.html#wp1213573Peter
