Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi I'd like to ask why is it that on our Ironport WSA. The WSA's IP address is listed as the top client's IP's with malware connections detected on the L4 traffic monitor?
Thanks,
udimpas
Hi, we have Ironport ESA deployed in one-arm mode. all incoming email passes through Ironport before for warding it to our Lutos server. The issue when we set Lutos server to relay outbound emails to Ironport for Security processing then Ironport sen...
Hi!
I am having this issue with newly installed virtual Ironport ESA. Before Ironport virtual appliance was installed (without any anti SPAM solution). Incoming/outgoing emails are sent to intended recipients as well as a lot of SPAM emails which r...
Hello, Got 2 ASA 5505 connected to each other via L2L IPsecVPN. I can RDP a server from my remote location to HQ site but cant RDP from HQ to remote site. VPN is up and running ok. I can ping any server from both sites. I have attached running config...
Hi, I'd like to ask some clarifications regarding GET VPN. Can I configure GET VPN on my internet facing routers? If no, does GET VPN can run on top of an existing DMVPN? Or is it limited to private WANs only.Any feedback is hihgly appreciated. Thank...
Hi Matthew,
Apologies for the late reply. I was out due to long holidays.
We have set the configuration mentioned above during the initial setup of the ESA. We found out that the issue is with the Notes server smtp connector configuration. The new ...
Hi Auraza,May I ask the command on the ASA side? My problem is I wont be able to connect thru RDP. Im using ASA5505 on both sites. Attached are the running configs (IP Address and other configs has been omitted)Thanks,udimpas
