Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am monitoring all devices in the lab2 and I am seeing duplicate alerts on our monitoring system for almost all devices.After looking into the configuration I noticed lab guy is running management And uplink connections of nexus devices to the Core ...
Hi,I am working on nexus 7009 and I am getting Alert on Librenms (monitoring software) for down power supply&fan although when I check switch log (sh logging) there is no log for down power supply.So I took a screen shot during the alert and after...
I am working on WS-C4948 and I have notice that when I run *sh interface ... I am having the following error#sh interface gigabitEthernet 1/48GigabitEthernet1/48 is up, line protocol is up (connected)Hardware is Gigabit Ethernet Port, address is 0017...
I'm using Librenms to monitor switches.Management port is the management port on the Nexus switch xUplink port is one of the port on the Nexus switch xBoth uplink port and management ports are connected to core.
Hi BalajiI am not getting any duplicate message on the switch. The only duplicate message is showing on the monitoring system saying "Duplicate ICMP response detected! This could indicate a network issue" with no extra details. So I'm wondering if ha...
Hi All,Sorry for not updating you. Suddenly Librenms stopped sending Alerts. I think what cause the Alerts is bug described in " https://bst.cloudapps.cisco.com/bugsearch/bug/CSCtf99048/?rfs=iqvred "Thank you all for your help.
I am using SNMP. Here is capture during recovery time I'll capture another one when I receive a new alertSnmpwalk for 1.3.6.1.4.1.9.9.117.1.1.2.1.2SNMPv2-SMI::enterprises.9.9.117.1.1.2.1.2.22 = INTEGER: 2SNMPv2-SMI::enterprises.9.9.117.1.1.2.1.2.23 =...
