hello,I would like to connect two ATM OC-3 modules:-3360, OC3 single mode, intermediate-cat 8500, OC3 single mode, long reachwhat should I put between both interfaces to make it working?best regards
hello,some of my clients are not able to access my SSL service. it is provider independent problem. All I know it's they are not albe to access my SSL when they are using NAT, but if they try from PC connected directly to the internet via the same li...
I have a problem with redundancy in CSS 11051. I use firewall load balancing and server load balancing. Load balancers which only load balance over 3 firewall switch from primary to master with no problems.problem is with load balancers which load ba...
Last week I have upgraded my HSRP cluster of two 7401 routers to the newset IOS 12.2(4)B6.After upgrade on one of my routers (lets call them A) IP and HSRP membership has been moved from interface G0/0 to interface G0/1.After that change router A has...
hello,what is the meaning of that bug?===CSCdx35082 - When the CSS detects a mid-NAT reject, the RST (reset) going back to the client has a sequence number of 0.===at the momement I use CSS 11005 with app v 5.00. I have two layers of CSSs: -one I use...
clients with that problem tells they are able to access other ssl services - only with my they have problem. So I belive they have proper configuration.
here they are:===dial-peer voice 1 pots destination-pattern 39.. no digit-strip port 6/0:15!dial-peer voice 2 voip destination-pattern 225760... progress_ind setup enable 1 session target ipv4:10.10.1.1 ip qos dscp cs5 media ip qos dscp cs5 signaling...
