Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,we configure the followand our wish is to connect a client per netbios with an host (SNA) Router1 (RSM, 12.0.17))dlsw local-peer peer-id 192.168.10.200dlsw remote-peer 0 tcp 192.168.88.1dlsw bridge-group 1interface Vlan14 description VLAN Hors...
Hi all,my customer change from Token Ring to Ethernet since the change the netbios traffic performance fall from 230kbit/s throuput to 18kbit/s.IP traffic is not be affected, IP runs with 230kbit/s.We have an Ethernet-(Router1)-2MbitWAN-(Router2)-Eth...
Hi all,i have the following setup.Ethernet1 - (Router-Bridge) -TR1 ---Serial---TR2now i change my setup toEthernet1 - (Router-Bridge) -TR1 ---Serial---TR2 - (Router-Bridge) - Ethernet2-my problem is that the port of the link to the Ethernet2 goes to ...
Hi Leon,i think you should configure the EMI-Switch to the Master.Switch(Conf)#Switch prio (example) 15,These should lose your problemBest regards RainerDimension Data
Hi Matthias,the Client use the "Personal Communication" (3270)The Host Macaddress on the Ethernet 4000.7060.2222The Client Macaddress (Ethernet) 0050.048f.50e4Best regardsRainer
