Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello All,
I have a question that I hope someone can help. I have an ASA 5545-X firewall with the embedded management port (Management0/0) configured with an IP address. The other four interfaces on the ASA (GigabitEthernet0/0, GigabitEthernet0/1...
Hello,
I have a question on dynamic GRE Tunnel Setup that I hope someone can help. The issue is in my tunnel setup, I need the local tunnel's destination on R1 to be whatever IP address that the remote tunnel's source on R4 acquires from its IP DH...
Hello,
I have a question that I hope someone would be able to help. Basically, I have a router (D1) that has two links to two different remote routers (Core-RT and NRR1). D1 runs OSPF with Core-RT while D1 runs EBGP with NRR1. When I ping a host (...
Hello,
I have a question that I hope someone can help. For some reason, I cannot ping the networks behind MGGS1-RR1 from the Core-RT and vice versa. When I issued the "show ip route" command on MGGS1-RR1, I only saw the two directly connected netwo...
Hello,
I am trying to get my IBGP router to ping an EBGP router and vice versa across an OSPF network without success. I have attached a diagram for your information. I would appreciate it if you could help shed some light on the issue. Thanks.
...
Thanks coffee. I am thinking of writing EEM scripts to make the router D1 to switch to OSPF link as soon as it comes back online. The challenge is I have no experience in writing EEM...
Hello cofee,
Thanks for your reply. I have enabled OSPF bfd on the interfaces between D1 and the Core-RT and BGP bfd on the interfaces between D1 and NRR1 and noted that I still have to perform the "clear ip bgp *" command in order to force the tr...
You rock!!! I am able to ping back and forth after adding the recommended changes and removing the unnecessary lines in the BGP configuration files. I am truly amazed by the knowledge and expert advices from this Support Group.
Thank you very muc...
Hello Mink,
The output provided earlier was generated after I inserted the static route into MGGS1-RR1 as follows:
ip route 10.10.10.0 255.255.255.0 10.10.40.2
I really want the routes to learn through BGP and not static routes. Is there a way t...
Hi Mink,
Please see the output from the show command that you suggested.
NRR1#sho ip bgp neighbors 10.10.40.1 advertised-routesBGP table version is 22, local router ID is 3.3.3.3Status codes: s suppressed, d damped, h history, * valid, > best, i ...
