After I assigned a IP to the control interface, I use a work station to ping the interface, however, it always says "can't reach"In the 10.1.1. network, there only 2 IP, and do not have a router, hub or switch.The 4210 control interface's IP is 10.1....

I am the Cisco user and this is my first time to use your poduct IDS-4210 Sensor.i have followed your instructions step by step from the document.Unforunately,in the part of initial configuration utility step 6 (communications Infrastructure ),I am n...

I try to change the config. of the sensor by use sysconfig-sensor command.After I use the "Communciations Infrastruction" and try to save the config. ,the sensor says :cp: cannot create /usr/nr/etc/eventd.conf: Read-only file systemERROR: Could not c...