Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
From a while now we're having an issue with one of our Lan interfaces on a cisco 3845 router.
The number of flushes on the interface keeps increasing and i'm not sure why.
After searching on the internet I've come across the SPD (Selective P...
Hello,
My WSA is on version 9.1.1-074 and I'm having a problem whenever I try to edit my Bypass Settings list or change a custom URL Categorie.
On my Bypass Settings, even if I don't edit NOTHING at all and just click "submit" after clicking on "Ed...
Hey Georg,Unfortunately increasing the spd threshold had no visible effect on the interface flushes. I've increased the spd threshold to 512 and after seeing no improvement I increased again to 1024 which started to increase the "no buffer" counter f...
You can see below the output:GigabitEthernet0/0 is up, line protocol is up Input queue: 0/75/0/191 (size/max/drops/flushes); Total output drops: 0GigabitEthernet0/1 is up, line protocol is up Input queue: 2/2500/0/37667151 (size/max/drops/flushes);...
Hey Georg,Thanks for recommending this document and after reading it the only doubt I have is regarding resources.I've understood that even though my hold-queue on interface gi0/1 was increased to 2500 the packets on that interface are flushed after ...
Since the router is in production, I can't cause any downtime in it, I rather do this after 5 PM, or is it completely safe to do so anytime?Just to be sure, I'll have to increase the values on ALL interfaces including the LoopBack and the 2 tunnel in...
I also posted 3 pictures there are inside the "spoiler" tag that contain the spd and switching output.Thanks for the quick reply!!! MTU 1500 bytes, BW 1000000 Kbit/sec, DLY 10 usec, reliability 255/255, txload 1/255, rxload 1/255 Encapsulation ...