Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I encounterd a problem with giga connection with Cat.6 UTP Cable.I tried to transfer a huge file through the giga connection. However, the max speed is just 160Mbps.Is there any specific procedure for the proper speed?I think 160Mbps is not the adequ...
I'm operating a Cisco4700 Router.Today, a configuration was automatically(i'm not sure) issued that was 'nrzi-encoding' on a serial interface and the communication between the interface was not worked any more.I tried to search about the command, but...
What is the abort count in the output of 'sh interface'?If the abort count increase in number considerably,what kind of symptom can be likely to happen?And what can I follow up?
Hi! there...I have a problem on a Cisco3745 with Hssi interface...This is my simple topology.C7513---<HSSI>---C3745---<100MB>---Cat3550.When I tried pinging from the Cat3550 to Hssi interface of the C7513, there are so many ping loss.Cat3550 to FE of...
Hello! I have a Telecom site using iso-igrp.Recently, the backbone was changed to Gigabit Ethernet and we have a problem. Everything is OK, but only some server(sun) can not transfer any clnp to Cat6509. However they can communicate each other and co...
Thank you for your reply... Below is my output of "show power".I don't think the power is not too small to care of the switch.-----------------------------------------------------system power redundancy mode = redundantsystem power total = 1153.3...
Hi... I really want to know what kind of situations can happen '0 successor' in eigrp neighbor table even if there is a path has FC is satisfied as a successor. Anybody know about this?
HiAs I wrote, the Router can send any packet to the switch but the switch can not.The switch just recieve from router, so CDP neighber can verify on the switch.But not in the router because router can not recieve any packet from the switch.And I trie...
I tried to change the duplex and speed.From 10/half to auto/auto and auto/auto to 10/half...But there is no change...As you've seen what I wrote, the router has only output count(no input) and the switch has only input count(no output)... And the swi...
