Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Everyone,Here is the design.4402 internal controller in data center4402 DMZ Guest controller in data center1242AP behind firewall at remote sitesI had this working, and then all of a sudden DHCP stops working for the clients.The DHCP scope is defined...
Hello all,I am trying to provide DHCP services to Cisco 1242AG APs via the PIX firewall.Does anyone know if the PIX 515 with IOS version 6.3(4) supports the proper syntax for DHCP option 43 and 60.Although I enter option 43 with dotted notation, the ...
Hello,I am working on an implementation of a hub and spoke WAN network using a HSSI network module in a 3640 connecting to a Digital Link IMUX. We are connecting two T1's to start with and there are 22 remote sites with Fractional Frame Relay access...
Hello everyone,I have two different applications and I want to make sure that I understand the difference between the two port adapters, PA-A3 and PA-T3+. We are currently installing a new SONET ring and migrating some WAN ATM DS3 connections over t...
Hello all,quick question about proper code for the following configurationCatalyst 5509SUP III GDo I use the SUP III code or the SUP G code?Also, how do I see the name of the actual code that has been uploaded to this switch. The show flash and show...
Well,I will have to get Cisco back in on Monday. They had it working and some how I managed to hose up the DMZ guest WLC providing dhcp addresses from the internal wlc DHCP server.I will post the resolution when I get this resolved.Thanks for your he...
The guest wlc is configured like thisdynamic interface --> vlan3=dmz3management/ap-mgnt interface --> vlan4=dmz4Clients tunnel to the guest wlc via dmz4 and exit to dmz3 as nodes on the vlan.The virtual interface has the same default IP on all contro...
Q. This is on the DMZ Anchor wlc, under the WLAN/Edit/Advanced/DHCP Server = 1.1.1.1Does this make sense? or should I have it assigned to the managment interface?On the internal wlc, I have the DMZ wlc mangement interface defined for the same wlan.Do...
I do have the same WLAN defined on both wlc.I have no scope defined on the internal wlc.On the internal wlc for the wlan I have dhcp defined as the managment interface of the DMZ wlc (anchor).On the internal wlc I have the wlan interface defined as t...
Hello,We are currently implementing something similar at my site. If your LAPs are behind the firewall in the vendor DMZ and your controllers are on the inside of the firewall, below is what I believe is happening.We do use the PIX/ASA to provide DHC...
