Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
During tests with the new CW9176 APs, I noticed that the APs expose a second MAC address to the switch.For example, if the Ethernet MAC of the AP ends with bff0, then bff2 also appears on the switch port.
Only the primary MAC — the one labeled on...
Hello,i have two C9800-40 Controllers, both installed via image (.bin) in bootflash: via install add command. Now i have one who installed in bootflash:, boot system bootflash:packages.conf and the other one in harddisk:, boot system harddisk:package...
Exactly, that's why this is an issue at an implementation we are doing at the moment. I'll proceed and address that to TAC. Will post here if i receive any information.
Hello, was somone able to find a solution? We are expierencing "same" issue with various older clients in customer environments. In simple WPA2 AES PSK networks as well. Cisco 1242 as WGB for example.Same log output saying no response to eapol m1.No ...
Tried differnet IPs and it is working now.Not working: WLC1: 10.2.0.1 /24 WLC2: 10.2.0.1 /24, Working now WLC1: 192.168.5.1 /24 WLC2 192.168.5.2 /24I really don't know why this should be a problemCan be CLOSED. Thanks to you all.
Hi,double and tripple checked this document by now. i also cleared ha configuration and did it again and again.WLC9K-1#sh version | in 16|InCisco IOS XE Software, Version 16.12.01Cisco IOS Software [Gibraltar], C9800 Software (C9800_IOSXE-K9), Versio...
Hello,problem solved with different boot vars. 16.12 seams to expand where it lays when installed. So sollution was to copy .bin into bootflash:, boot from that in bundle mode. Set boot system to bootflash:packages.conf, Installed via install add.Now...
