Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I created a flow record on an edge (access) switch. One of the Port channel physical interfaces has a high utilization (rx load). Several of the top talker flow destinations are not on the switch. But somehow the flow is still on the edge switch. All...
I have two 2800 routers connected via their serial ports. I call them Top Router and Bottom Router. I have my top router connected to my home network through it's g0/1 port. I can SSH into Top Router. I can ping Bottom Router and home network from To...
I wonder if the transit flow is what is causing the rx load (high utilization) on the edge switch. It is dicom traffic and we have a host that can send and receive dicom traffic. That is really what I am trying to figure out, what is causing the rx ...
Router A can ping home network (192.168.0.0) and 10.10.10.0 network. Router B (10.10.10.0) network can ping Router A interfaces G0/1 (home network) and s0/0/0 (10.10.10.0) networks, but cannot ping any other 192.168.0.0 addresses. Only the g0/1 inter...
I erased my configs and started over. My Router B, still not pinging the default gateway. Here are my configs:
Router A (Top Router)
interface GigabitEthernet0/1 ip address dhcp duplex auto speed auto!interface Serial0/0/0 ip address 10.10.10.1 255....
