Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have just recently switched to using a pix 501 from a Linksys RVS4000. Using the RVS4000, I was able to establish an IPSEC VPN through that fw, but I've been unable to get the configuration correct for the PIX 501. It is supposed to support IPSEC...
Hello, I've dl'ed the latest set of drivers and PCMCIA firmware in an effort to get the 802.1x eap-tls authentication functioning on a iPaq WinCE 2002 PPC. I am using MS IAS for the radius server that the AP hits and the AP is running 12.02T1. The ca...
I have a 501 with an inside address of 172.29.123.253. I have a static route on the inside of '192.168.254.0 255.255.255.0 172.29.123.60 1'. This route points to another router that has the 192 network on its other interface. I also have RIP v2 ...
Well, I've tried that before, BUT...no one said it needed to be at the far end. Since I am going through one Pix to terminate the tunnel at another, and it worked fine if the VPN Client was in the wild (internet connected outside of the firewall), I...
Rajet,Thanks for your help with this. Your configuration flow is correct. This small business has two locations with separate Internet access and they need to VPN in to each other at times. So both of the firewalls are configured to be VPN gateway...
Rajat,When not behind Pix501(2), the vpn client connects to Pix501(1) without problems. Only when the client is behind Pix501(2) do I not get the return data. The client connects, just doesn't get the data responses from 501(1). This is not a 501-...
