Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Can anyone show me the link to the document about the following PIX topics:Enterprise PIX Firewall ManagementEnterprise PIX Firewall MaintenanceFirewall Services Module overview and with PDMThank You!Simon
Dear Sir,We have 2 PIXen (PIX525 and PIX515). Both PIXen are configured for VPN Remote Access using PPTP and working good. Now we want to add Site-to-Site VPN using IPSec on both PIXen by following this doc link http://www.cisco.com/warp/public/110/3...
Dear Sir,We have two PIXes (PIX1 at HQ and PIX2 at branch). Both PIXes are configured for VPN remote access using PPTP and working good. Now we want to add Site-to-Site VPN using IPSec to both PIXes. Each PIX is connected to Internet via cisco router...
Dear Sir,Below is my VPN configuration on PIX515 and works for VPN client to dial in from a public network.I am having problem to connect this PIX515 VPN from a client at inside interface of PIX525. I got error message at client computer: "Error 721:...
Dear Sir,I am configuring PIX-to-PIX VPN tunnel using IPSec/IKE and would like to use the PIX local database for authentication, not using external TACACS+ or RADIUS server. Can someone show me what command can be used for PIX local database authenti...
Thank you Sir for your reply. Looks like I am almost there.I have listed my config below and have following questons:1.Check the 172.16.0.0 network and make sure there's a route to the 192.168.100.0 network that points to this PIX. My answer: I belie...
Thank you very much for your help. That resolved my problem to access VPN using PPTP. But for some reason, my VPN using IPSec did not work. I have followed this doc linkhttp://www.cisco.com/warp/public/110/38.htmlto config my PIX-to-PIX VPN using IPS...
Thank you for your response. I have applied my config to both PIXen but it did not work. I guess the following two reasons that cause the problem:1. My perimeter device (cisco 3640 and 2500) did not have open port for IPSec traffic. What is the comma...
Thanks for your prompt reply. My pix525 is not configured with PPTP fixup and I am not sure if my pix525 block tcp1723 and GRE protocol or not. Can you show me how to configure PPTP fixup and how to check if my pix525 block tcp1723 and GRE protocol ...
