About pcavicch

pcavicch · 11-10-2003

Hello,I would like to know if is possible to configure two PIX 515 for failover without a failover cable.In other hands: is it possible to use an ethernet interface (already used for a DMZ) to exchange the "heartbeat" between two PIX 515 ?Thank you i...

pcavicch · 09-23-2003

Hello,my PIX is the Default Gateway for my LAN.Can I configure a static route in my PIX 5151E to route packets from my LAN to another gateway in the same LAN?Thank you in advance

pcavicch · 08-04-2003

Hello,I need to check the incoming ISDN call for both the username and the Calling number.For example: I need that my dialing user could connect to my Cisco 2600 (or an AS5200) only if:the username/password is correctANDthe Calling ID is a known tele...

pcavicch · 07-09-2003

Hello,I'm in a trouble.I've just configured a Cisco 3600 to accept LAPB-TA incoming calls.My customer is calling, but the 3600 doesn't accept the incoming call.Here below I copy some row of the debug output:=== debug output ===*Mar 1 23:57:42.126: I...

pcavicch · 06-02-2003

Hello, I need to connect a Meridian Opt 11 to a CCM in my network. The target is to call directly with internal short numbers from my legacy PBX phones to my new IP Phones, managed by a Cisco Call Manager. I think this is possibile with a Cisco Voice...

pcavicch · 07-16-2003

Hello,I haven't access to the document.Please, could you send it to me?Thanks in advancePaolo

Member Since	‎10-23-2002 03:49 AM
Date Last Visited	‎08-18-2017 03:51 AM
Posts	14

User Statistics

User Activity

Failover cable for PIX515E

Does a PIX route packets from a LAN to the same LAN?

How to check both username and Calling ID

LAPB-TA (X.75) incoming calls not managed correctly

Connecting a PBX Meridian 1 OPT11C to a Cisco Call Manager

Re: LAPB-TA (X.75) incoming calls not managed correctly