Hi, I recently got a CISCO AP1852i (running Mobility Express 8.5.151.0) and I'm struggling to set up a working wlan (meaning with internet connection).I believe most of my issues come from the fact it's not a standalone AP but rather a hybrid device ...
Hi,
I'm studying NAT and there is something I don't understand about dynamic NAT so maybe you guys can help.
I have used both Packet Tracer (7.1) and a small lab to test NAT.
My topology is quite simple : 3 PC/clients, a switch, two routers (A/B)...
Well I guess the title was wrong since I do not think it's a wlan or vlan or dhcp or even gateway issue. I have disabled the wlan.It's even more simpler than that : the controller does not access the internet.The controller is on my lan (172.16.100.0...
I double checked the NAT on the PFSense router and it's ok as far as I can tell. However I changed a few things like moving from 101 to 110 for the wifi vlan to avoid mistyping. My new config : POOL 1: day0-mgmtMANAGEMENT NETWORK: YESNETWORK: 10.10.1...
Ok, fixed a duplicate address problem. VLAN interface on pfsense router and switch was the same so now vlan 101 int on router is 101.1 and on switch 101.2.Can ping vlan 101 int on switch now. Still cannot go out.
Just tried with a laptop.IP 172.16.101.5/27 GW 172.16.101.1 (the VLAN interface on the switch)Cannot ping the GW.The port is a trunk (all vlan allowed). I also tested configuring the port as an access for vlan 101, same result.
Self-reply :p
I was forgetting a simple thing:
hosts number < pool : Dynamic NAT w/pool
hosts number > pool : Dynamic NAT w/pool+overload
Makes sense now.
Good day!
Eric