Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've been working on solving a performance issue between two sites. The ISP site is using a BR500 configured as an AP off an Omni. My remote site is using an MC4800 bridge connected to a directionalover 25' of LM400. There is good LOS between the ...
I'm using a MC4800 workgroup bridge to connect to my ISP. The MC4800 is running at full power (100mw) and is attached via 25' of LMR400 to a 16.5dbi panel with clear LOS to their AP/Bridge. The AP/Bridge is a BR-500 located about 1.5 miles away accr...
I have the same issue with our AP 350's running IOS. For some reason, clients keep being deauthenticated. In my case, it's always for excessive retries. This happens with Prism and Orinocio (hermes) cards, I use long headers/preamble. The detailed ...
I'll second that... My AP350 was pretty much useless after the IOS upgrade. The only cards that would hold an association were Cisco cards. None of my Orinoco Cards would work, forget Prism. My old Aironet cards caused the AP350 to crash... Forget IO...
I have the same problem with my AP 350. It all started after the upgrade to IOS. None of my Orinoco card will hold an assocation long. They keep dying with max retries exceeded. Unless I'm right next to the AP, the rate drops to 1Mbs. My Cisco radio ...
