Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everybody
i'm trying to enable service nagle via CLI but my SG500 returns that its an unrecognized command... Could anyone help please ?
SG500 with 1.3.0.62 firmware version.
Thanks a lot!
Hello everybody,
Please I have a SG500-52port managed switch and I'm trying to add a custom SmartPort roles and set these customs to gi1/x ports.
I've done creating custom Smartport roles but I see errors when try to attempt this to gi1/x ports a...
@Flavio Miranda
Thanks for reply! Then i can't use this switchport with port-security, right ? ( just to confirm )
I'm using this CLI guide also... About the Service Nagle... is it the same case ?
since now thank you so much
@Flavio Miranda
Another information... i'm using SG500-52port with 1.3.0 firmware... but even in 1.4.x CLI user guide, i can't found these commands like service nagle and switchports
@Flavio Miranda, yes i can select the interface gi1/X in conf t and set it to switchport mode access but after i can't set switchport mode host or switchport host
switchc04d73(config-if)#switchport mode access
switchc04d73(config-if)#switchport hos...
@Flavio Miranda,
Obrigado pelo retorno porém não funcionou, o comando retorna unrecognized command. Tem alguma outra sugestão do que pode ser ?
Obrigado!
Thanks for reply! the switchport access don't work and this command returns unrecognized com...
