About ARUN02

ARUN02 · 01-30-2019

Hi, cisco 1841 router configured double BGP but one bgp state active only. link port is up ,when restart the router then only BGP is working.

ARUN02 · 11-06-2018

Hello everyone How to configure Management VALN in switch 2960, I want to configure remote access. currently working vlan1 but i want to configure VLAN100 with ip address and shutdown VLAN 1. --------------------------------------------------------...

ARUN02 · 10-30-2018

Hello, cisco 2921 router how to configure bgp ? why need to static route 0.0.0.0 0.0.0.0

ARUN02 · 11-07-2018

YES, change to the management ip address remotely over an ssh session switch version : 12.2

ARUN02 · 11-07-2018

sw version 12.2switch image: C2960SM-LANBASEK9-M

ARUN02 · 11-07-2018

Hi, switch ip : 192.168.1.1 this vlan1 configured I need to shutdown vlan 1 and create the new VLAN using remote only how to create. Interface IP-Address OK? Method Status Protocol Vlan1 192.168.1.1 YES manual up up

ARUN02 · 11-07-2018

Hi, currently working VLNA 1 i 'll configure to remote SHH. vlan1 ip address removed then how to access that switch ?

ARUN02 · 10-30-2018

Hi, check to bridge mode configuration on the device.

Member Since	‎12-07-2017 03:55 AM
Date Last Visited	‎11-16-2024 06:52 AM
Posts	8

User Statistics

User Activity

BGP active issue

How to configure VLAN in SSH?

What is BGP ?

Re: How to configure VLAN in SSH?

Re: How to configure VLAN in SSH?

Re: How to configure VLAN in SSH?

Re: How to configure VLAN in SSH?

Re: Config PPPoE in Router 2811