Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi - i have 2 core switch Which is CoreA and CoreB , my CoreA is getting host flapping message.
8490397: Nov 14 11:00:46.086 MYT: %C4K_EBM-4-HOSTFLAPPING: Host 04:D6:AA:31:9F:55 in vlan 27 is moving from port Te2/7 to port Te3/128490398: Nov 14 11:...
Hi ,
Recently , I have a problem about upgrading From Old ASA 5510 to ASA5508-X and when finish deploy the new ASA5508-X and found the internet will goes down after 30 minutes. when i switch it back to Old ASA5510 and it is working fine , i found s...
Hi Guys,
I am facing of my ASA 5506-X firepower was not working , had try to follow cisco datasheet setup accordingly but problem still persists.
Please help...
Card Type: FirePOWER Services Software ModuleModel: ASA5506Hardware version: N/ASe...
Hi all,
I have done with my anyconnect vpn. but after anyconnect vpn is connected, I can not connect to my asa5506-x using ASDM. i have added management-access inside and it was able to ping but still cannot access.
interface GigabitEthernet1/2 ...
Hi all , recently i have purchased a cisco anyconnect plus license (AC-PLS-P-50-S) for upgrading my cisco asa 5510
before:
Licensed features for this platform:
Maximum Physical Interfaces : Unlimited
Maximum VLANs : 100
I...
Hi Leo,
Why must it be in a etherchannel , the access switch has 2 uplink connected to both core switch which also running spanning-tree , how was this issue happen ?
Hi Balaji,
1. you have mentioned 121.x.x.x for ASA, how is your DSL Modem configured for this ?
121.x.x.x / 30 example : ASA=121.x.x.42 and ADSL=121.x.x.41
2. if the internet goes down after 20min ? if you reboot the ASA or DSL, did the internet...
Hi Marvin,
I am following the below picture to do.
Direct cable connect between M1/1 to Gigabitethernet 1/4 , i haven't try to plug in to switch as this ASA was a new deploy at my client site and i'm actually access this ASA via WAN , haven't ...
