Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,
I have two N5K and 2 no of N2K, FEX and VPC configured.
Whenever i connect GLC-TE or any SFP (MM or SM) its not detecting but if i reload the N2K (like power off and ON back) then its detecting. What is the reason and how to fix it.
Thanks
Hi All
What is the procedure to install the license after generating license using the below PAK and whether any restart is require after installing the license? Thanks for your support
Any prerequisite?
R-MGMT3X-N-K9R-PI30-SW-K9
L-MGMT3X-AP-K9
...
Hi
thanks for your reply.
the port is in shutdown state while configuring port speed , port config(access/trunk). Then i insert the GLC-TE and issue no shut command but still N2K not detecting the GLC-TE (including SFP 1 gig, 10gig, mm , sm in any c...
