I have 2 routers, Marvin and champion. Both connected via Internet. But, Champion, 192.168.3.0 subnet does not seem to be able to browse Internet. Why?Marvin Routerinterface tunnel 0ip address 10.1.1.1 255.255.255.0tunnel source 203.1.1.1ip nat insid...

I have 2 router, router A and B at two different locations. RA at HQ and RB at branch.RA routerint tunnel 0ip address 10.1.1.1 255.255.255.0tunnel source s0/0/1tunnel destination 203.1.1.1tunnel mode gre ip!int s0/0/1ip address 202.1.1.1!int eth 0ip ...

I have 2 links to diffrenent ISPs. Running BGP as well on both links.How do I configure the BGP so that link 1 to ISP 1 will always be the preferred link for outbound traffic?

I am using a PIX firewall. The external IP address is 203.11.1.1 and Internal IP is 192.168.10.3How do I allow PC connected to the internal segment be able to ssh into PIX firewall? Thank you.

I am tring to establish the VPN tunnel between my Malaysia and UK office using PIX firewall. But, it does not seem to work. I go the following error messages:local ident (addr/mask/prot/port): (192.168.10.0/255.255.255.0/0/0) remote ident (addr/ma...