Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, as a noob im running into difficuly setting my 2600 router up for traffic shapping. I have a router with the following configversion 11.3service timestamps debug uptimeservice timestamps log uptimeno service password-encryption!hostname Router!!m...
Hi,I’m yet again stuck on setting up our routers.We have a router in Scotland configured on a 11.x.x.x network and a router 10.x.x.x in Rugeley these two devices works fine and traffic between is working fine. Scotland f0/0 -> 11.0.0.250Rugeley f0/0...
Having trouble setting up, probably the most basic setup ever. (Beginner)We have a lease line and two 2600 routers each fitted with a WIC-1T. I’m trying to setup our routers for network traffic can go between each network, the setup is as belowNetwor...
Does no one know? There is a link to a linux version using QoS called the wondershaper wonder if this helps http://lartc.org/wondershaper/ Many thanks againAndy
I do belive your right ive added a static route on the rugeley router and it no timesout which I think might be down to the gateway only allowing stuff on the 10.x.x.x networkTraffic flowRequest to 81.123.154.122PC on 11.x.x.x network -> Scotland(ROU...
Thank very much for your reply gpauwen. I have added the ip route into the scotland router the 11.x.x.x network. now when tracing the route it gets to the 192.168.1.2 (Rugeley Serial WIC) then I get destination host unreachable.============ SCOTLAND ...
Right I have no used cisco configmaker now to create the configs for each router as below<=== Rugeley ===>!service timestamps debug uptimeservice timestamps log uptimeservice password-encryptionno service tcp-small-serversno service udp-small-servers...
