Hello everybody,
my problem is that I want to isolate the Guest Clients in my network.
Here is my Setup:
1 x Cisco SG300-52p Switch
3 x Cisco WAP371
3 Vlans to separate and route the traffic correctly.
Up until now I accomplished with ACLs on...
Thank you for your advice. I cannot connect to the AP's through the CLI. There is only the web interface.
As you suspected my AP's run without a controller with the single point setup. So there aren't any options like "bridge group", PSPF or Peer to...
Thank you for your answer.
I think I will stick with channel isolation for the next time. This is currently the best setup I could get with my hardware.
Hello everybody,
I have three of these APs in use in a cluster and I don't have such issues with them.
Here is my setup:
Firmware Version : 1.3.0.4PoEBoth Radios activated4 VAPs activated: 3 of them are tagged VLANs The APs are inside the default...
