Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello.How can I display any packet denied due to security policy. I can run a query, but then I only get the total amount of session not the actual session. If I use a rule and incident I can see all the denied hosts but with several different incide...
I have the following search filter to find a users in a specific group:memberOF=CN=CleanAcess,CN=Uses,DC=daxlabm,DC=noCan anyone provide me with a working LDAP query?
Hello,I have a problem, I have defined a vpn policy for my split tunneling traffic which works fine as loong as my users are connected. When the users disconnects, the CIC is still running but with default policy (block all) how can I use the same po...
have a lot of equipment on my hand from my CCNA,CCNP and CCSP exams. I want to share the equipment since it's not doing me any good right now. Does anyone have a sugestion on how to do it? I will need some kind of scheduling system and telnet access...
Cisco does have a solution for this, even a configuration guide on the tech support. Take a look here:http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a0080094763.shtml
Correct, the problem is when a client uses the VPN at home to access office resources, then when he or she comes into the office next day the default policy is still enabled not allowing them to have sertain access to some management systems defined ...
You must use access-list 1 permit ip any anyaccess-list 2 deny ip any anyand the ICMP permit any echo-reply outside to enable ICMP trafikkDue to Adaptive Security Alogrythm (ASA) by default the PIX only let trough trafikk that origens from the inside...
Hello Scott,I have one WIC adsl card laying around, I was just wondering if I could use it in the PIX to eliminate my 827 router. I have just bought my cisco lab and are just playing around at the moument.
Hello Rick,Sorry to boder you but I'm working my brain out here... I have configured a 2610 with 4serial interfaces (I have degraded the IOS version to 11 Enterprices with is supose to work with this solution) as the frame switch as described under. ...
