Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi allI've a 1801 router with a recently erased NVRAM with command "write erase".When i plug the ethernet cable of my internet provider and i reload it, it autocinfigures with some config that my provider sends, including the hostname, the fastethern...
HiI?m trying to use a free internet acces via ISDN of my provider but i can?t no get IP address from it and the call goes down inmediatelly.I?ve performed the command "ip address negotiated" in the bri0 interface but i think that is not enough becaus...
Hi allrecently i?ve purchased a 1801 for enable an isdn backup for my internet access via ADSL.My first problem is that i need to use NAT to gain internet access from my network behind, but i don?t wnow how to proceed for enable it for ADSL and bri i...
Hi allThe branch office of my company have no backup line and i need to implement it.Actually we have VPN using ADSL and PIX 506 on each office (Central and branch).Could you suggest me your preferred ISDN backup system for this scenario?I´m looking ...
Thank you patrick but i don't think so Look at my fastethernet0 interface, the default state is in shutdown and no ip address but in my case, selfs configure at ip address dhcp, no shutdown and i obtain public address from my provider with no command...
SUCCESS!!!yourname#ping 66.102.9.104Type escape sequence to abort.Sending 5, 100-byte ICMP Echos to 66.102.9.104, timeout is 2 seconds:!!!!!Success rate is 100 percent (5/5), round-trip min/avg/max = 84/87/88 msI?m surprised, i don?t no why a week ag...
Here you are the new outputAdditional info:1- isdn, TR1 and cable between tr1 and router has been chacked today by the provider technician and was ok and error free.2- Note that sometimes the call try by bri0:2Regards
Of course, attached you can find the router config and debug ppp negotiation and authenticationnote that the router is factory rebooted for avoid old bad commands and only configurated for run with bri0 for internet access.
Hola EduardoI´ve similar issue as you.I need to build a ISDN backup tunnel of a main ADSL VPN tunnel with fixed IP using the different and dynamic IP´s provided by Telefonica when ISDN comes up due to a ADSL failure. Whe could keep in touch at miquel...
